4-13. SEAT AND CUSHION (cont)
CLEANING, INSPECTION, AND REPAIR
Drycleaning solvent P-D-680 is toxic and flammable.
Wear protective goggles and gloves and use only in
a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not
use near open flame or excessive heat. The flash
point is 100 - 138°F (38 59°C). If you become dizzy,
get fresh air and medical aid immediately. If contact
with eyes is made, wash your eyes and get medical
Clean metal parts with drycleaning solvent.
Clean seat cover with detergent and water.
Inspect metal parts for cracks, breaks, and damage. Inspect base (4) for wear.
Inspect the seat cover for rips, tears, and wear.
Repair as required.
ASSEMBLY AND INSTALLATION
Position base (4) on cab floor and install four screws (3).
Position spring (2) on top of base (4) and slide seat (1) onto base.
Position box (9) on cab floor and install four bolts (7) and flat washers (8).
Position cushion (6) on box (9) and install six screws (5).