4-16. WINDOW GLASS AND SASH (cont)
CLEANING, INSPECTION, AND REPAIR
Drycleaning solvent P-D-680 is toxic and flammable.
Wear protective goggles and gloves and use only in
a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not
use near open flame or excessive heat. The flash
point is 100 - 138°F (38 59°C). If you become dizzy,
get fresh air and medical aid immediately. If contact
with eyes is made, wash your eyes and get medical
Clean metal parts with drycleaning solvent.
Inspect seals for cracks, breaks, and damage.
Inspect glass for chips and cracks.
Inspect frames and sashes for cracks, breaks, and deformation.
Repair consists of replacement of damaged parts.
Place glass in seals (11) and (10). Place seals with glass in sashes (9) and (8).
Place sashes (9) and (8) in lower track.
Place upper track (6) in position and install 10 flat washers (5) and screws (4). Latch lock (7).
Place glass (3) in weatherstrip (2). Place seal with glass in sash.
Install weatherstrip filler (1) in weatherstrip (2).