TM 55-2210-223-24
TO 45A2-2-14-22
3-47.
INDEPENDENT BRAKE VALVE
This task covers:
a.
REMOVAL
b.
INSTALLATION
c.
TEST
INITIAL SETUP:
Tools
Tool kit SC 4940-97-CL-E12
REMOVAL
WARNING
Whenever the independent brake valve is
removed and installed for any reason, a stationary
vehicle airbrake test must be performed to check that
the independent brake valve functions properly in the
brake equipment arrangement. Failure to perform test
may result in injury to personnel.
Make sure air is drained before removal of the
independent brake valve. Residual air may escape
and cause injury to personnel.
NOTE
Independent brake valve must be repaired at intermediate general
support level maintenance facility.
1.
Remove three nuts (1).
2.
Remove independent brake valve (2) and gasket (3).
INSTALLATION
3.
Install gasket (3) and independent brake valve (2) and
secure with three nuts (1).
TEST
4.
Refer to paragraph 2-9 and perform a stationary vehicle
airbrake test.
3-184