TM 55-2210-223-12
TO 45A2-2-14-41
NOTE:
WELD BRACKET TO FLOOR
OF FLATCAR ON LOADING
PROCEDURE CUT THE SAME
WELDS
ON
UNLOADING
PROCEDURES.
(11)
Weld angle iron bracket of wheel chocks to bed of flatcar. Weld a continuous 1/2-inch (12.7 mm) fillet on
each edge of angle bracket touching bed of flatcar.
(12)
Place stabilizing jacks provided with flatcar directly under each jack pad on locomotive deck.
NOTE:
LOADING PROCEDURE
WELD BASE OF JACK TO
BED OF FLATCAR WITH A
3/4-INCH FILLET WELD 2
INCHES LONG ON EACH
CORNER OF BASE.
UNLOADING PROCEDURE
CUT THE SAME WELDS IN
LOADING PROCEDURE.
4-113
