TM 55-2210-224-12
4-14. ARMREST (cont)
CLEANING, INSPECTION, AND REPAIR
WARNING
· Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and
use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe
vapors. Do not use near open flame or excessive heat. The flash point is 100-138°F (38-59°C). If
you become dizzy, get fresh air and medical aid immediately. If contact with eyes is made, wash
your eyes and get medical aid immediately.
· Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Do not direct
compressed air against skin. Use goggles or full face shield.
3.
Clean metal parts with drycleaning solvent and dry with compressed air.
4.
Clean armrest cover with detergent and water.
5.
Inspect metal parts for cracks, breaks, and damage.
6.
Inspect armrest cover for rips, tears, and wear.
7.
Repair as required.
INSTALLATION
8.
Position two hinges (5) on cab wall (6) and install six flat washers (4) and screws (3).
9.
Position armrest (2) on hinges (5) and install six screws (1).
4-34
