• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE HOOD DOOR - TM-55-2210-223-12_104
UPRIGHT, CUTTER LEVER, AND STEP - TM-55-2210-223-12_106

TM-55-2210-223-12 Oil-Water Separtor 5 GPM Type Seprator 5 GPM Type A 3 Stage NSN 2090-010-076-5849 Manual
Page Navigation
  91    92    93    94    95  96  97    98    99    100    101  
TM 55-2210-223-12 TO 45A2-2-14-41 4-11.  ENGINE HOOD DOOR (cont) CLEANING, INSPECTION, AND REPAIR 6. Use a stiff brush and remove dirt and sludge deposits. WARNING Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use only in a   well-ventilated   area.      Avoid   contact   with   skin, eyes, and clothes and don't breathe vapors.  Do not use  near  open  flame  or  excessive  heat.    The  flash point is 100 - 138°F (38 59°C).  If you become dizzy, get fresh air and medical aid immediately.  If contact with eyes is made, wash your eyes and get medical aid immediately. 7. Use drycleaning solvent and remove grease and oil. 8. Inspect doors and door latches for proper working condition. 9. Inspect door hinges (10) for serviceability. 10. Inspect sheet metal for dents, cracks, or corrosion. 11. Replace missing or damaged parts. 12. Repair metal defects by patching, welding, and grinding smooth.  Paint repaired parts. 13. Lubricate latches and hinges with lubricating oil in accordance with LO 55-2210-223-12. ASSEMBLY 14. If removed, position and weld three hinges (10) to hood and door (2). 15. Position spring guide (9) and lock (8) on inside of door (2) and weld to door. 16. Install two rods (6) through brackets on door (2) and position spring (7) between rod and lock (8).  Install two flat washers (5) and cotter pins (4). 17. Position handle (3) on door (2) and into lock (8) and weld handle to door. INSTALLATION 18. Position door (2) on frame and insert three pins (1). 4-21







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.