• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
MAIN GENERATOR (cont) - TM-55-2210-223-34_154
MAIN GENERATOR (cont) - TM-55-2210-223-34_156

TM-55-2210-223-34 Locomotive Diesel-Electric 06-1/2-Inch Gage 60 Ton 000HP 0-4-4-0 Wheel Model RS-4-TC-1A NSN 2210-01-158-2978 Manual
Page Navigation
  142    143    144    145    146  147  148    149    150    151    152  
TM 55-2210-223-34 TO 45A2-2-14-22 3-36.  MAIN GENERATOR (cont) REMOVAL (cont) 9. Refer to TM 55-2210-233-12 and remove exhaust flex pipe. 10. Install lifting eye and a suitable lifting device. WARNING Components of this locomotive are heavy and may be awkward to handle.  Use correct lifting procedures, indicated lifting devices, and/or assistance from other personnel to avoid injury. CAUTION Use extreme care to prevent main generator from damaging emergency fuel shutoff assembly. 11. Move main generator toward air compressor. 12. Slowly lift main generator from base and set on a suitable support device in horizontal position. 13. Mark locations of shims for installation. 14. Remove shims (22) from base.  Retain shims for installation. DISASSEMBLY WARNING Components  of  the  main  generator  are  heavy  and  may  be  awkward  to  handle.    Use  correct  lifting procedures, indicated lifting devices, and/or assistance from other personnel to avoid injury. Heated  parts  may  cause  injury  to  personnel  if  hand  protection  is  not  worn  when  handling.    Wear protective gloves for maximum protection. NOTE Some parts may have to be heated to release them from their shrink fit.  When this becomes necessary, the  use  of  a  portable  propane  torch,  a  portable  hydraulic  press,  and  a  puller  set  is  recommended  for disassembly. 15. Remove two capscrews (23), two washers (24), clamp (25), tubing (26), and two pipe elbows (27). 3-135







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.