TM 55-2210-224-12
4-32. HEADLAMP (cont)
REMOVAL
5.
Loosen door latch (1).
CAUTION
Lamp housing may slide off upper
mounting stud, fall, and cause damage
to equipment.
6.
Swing door (2) open and remove screws (3)
from sealed beam (6). Tag and disconnect
electrical wires.
7.
Loosen latch (4) and lower retainer (5).
8.
Remove sealed beam (6) from retainer (5).
INSTALLATION
9.
Position sealed beam (6) in retainer (5). Raise
retainer into position and tighten latch (4).
10.
Connect electrical wires to sealed beam (6) and
remove tags. Install screws (3).
11.
Swing door (2) down and fasten door latch (1).
12.
Set battery switch to CLOSE. Set applicable
headlight switch to ON. Check headlight for
proper operation.
4-83