TM 55-2210-224-34
3-25. ENGINE TEMPERATURE WARNING, MOTOR KILL, SAFETY, AND FIELD SHUNT TRANSITION RELAYS
(Cont)
DISASSEMBLY
3. Remove two capscrews (5), lockwashers (6), and flat washers (7). Remove support block assembly (8).
4. Remove two capscrews (9), lockwashers (10), and flat washers (11). Remove two capscrews (12), lockwashers
(13), and spring seat and springs (14). Remove armature assembly (15).
5. Remove nut (16), lockwasher (17), and flat washer
(18). Separate finger base (19) and support block
assembly (8).
6. Disassemble support block assembly (8) by the
following:
NOTE
All fingers are removed the same way.
Only one is shown.
a.
Remove nut (20), lockwasher (21), and flat
washer (22). Remove normally open finger
(23).
b.
Remove nut (24), lockwasher (25), and flat
washer (26). Remove normally closed finger
(27).
NOTE
All movable contact fingers are removed the
same way, only one contact finger is shown.
7. Remove spring retainer (28), wire spring (29), and
movable contact finger (30) from support (31).
8. Remove
screw
(32)
and
lockwasher
(33).
Separate operating coil (34) and magnet frame
(35).
3-101
