TM 55-2200-001-12
Change 1
Sec. 6-Fig. 65 (Rev.-11-1978) (Concluded)
(Drawing Redrawn 11-1978)
SEMI-TRAILERS-FLAT CARS
Item
No. of Pcs.
Description
M
6
1/2 in., 6 x 19 IWRO, wire rope doubled as a complete loop. On each side, pan wire rope through
stake pocket at rear of trailer through rear spring shackle or tie-down eye, at center
through center tie-down eye or over chassis frame, and at front through front tie-down
provision, or over frame member, or around Item "O" as shown. Secure each loop with
four 1/2 in. cable clips.
N
6 or more.
Thimbles or other metal filler to protect Item "M" at stake pockets, and if required, at
As required.
trailer attachment points.
O
1
4 In. x 4 in. x 81 In. lumber for attachment of Items "M" at forward end of trailer. Wedge
crosswise between ongitudinal trailer frame members. Secure to frame with wire,
Item "O".
P
1
Front Support, Block Pattern 90, Section No: 6. Length of upright support members and
other components may be varied to suit trailer type and height.
Notes:
1.
Items "0", "D", "H", "J" and "K" not required when built-up blocking, 6 in. wide, 18 in. long, height sufficient to fill space
between axle and floor, is used under each side of unit secured to floor with two % in. diameter bolts.
2.
Item "O" not required if trailer is equipped with forward tie-down/lifting eyes or if Items "M" can be secured over front
frame members.
3.
Units must be Jacked for application of Items "C", "D" and "F".
See General Rules 1, 2, 3, 4, 5, 7, 9, 14, 15 and 19-B for further details.
E-82
