TM 55-2210-223-12
TO 45A2-2-14-41
4-27. SANDER HOSE AND BRACKET (cont)
INSTALLATION
6.
Position rods (23) between ends of bracket (20) and install lockwashers (22) and nuts (21). Position bracket on
locomotive and install capscrew (19), lockwashers (18), and nuts (17).
7.
Position bracket (16) on locomotive and install eight capscrews (15), lockwashers (14), and nuts (13).
8.
Install nipple (12). Install three hose clamps (8). Connect hose (11) to fitting. Install pipe (10) in hose. Install
hose end (9) on pipe. Tighten hose clamps.
9.
Position bracket (7) on locomotive and install two screws (6), lockwashers (5), and nuts (4). Do not tighten nuts.
10.
Position pipe (10) on bracket (7) and place two U-bolts (3) around pipe and through bracket. Install four
lockwashers (2) and nuts (1).
11.
Adjust bracket (7) so that end of hose end (9) is 3 inches (76.2 mm) above rails. Tighten nuts (4).
4-68