TM 55-2210-223-34
TO 45A2-2-14-22
3-36. MAIN GENERATOR (cont)
ASSEMBLY (cont)
71.
Remove outer bearing stop (39) from heater. Install on armature shaft against bearing (40) and hold firmly in place
until cooled.
72.
Fill grease pocket in outer bearing cap (37) half full of grease.
73.
Install gasket (38) and outer bearing cap (37) and secure with six lockwashers (36) and bolts (35).
CAUTION
When stator frame assembly is being lowered on armature, check that parts are aligned and no binding
occurs. Binding of parts will cause damage of equipment.
74.
Install three lifting eyes on stator frame cover (55), one on each side.
75.
Use a hoist and slowly lower stator frame assembly (34) over armature assembly (43). Secure with eight bolts (33)
and lockwashers (32).
76.
Install two pipe elbows (27) and tubing (26) clamp (25) and secure with two washers (24) and capscrews (23).
WARNING
Procedures specify the heating of parts to aid in assembly. Heated parts may cause injury to personnel if
hand protection is not worn when handling. Wear protective gloves for maximum protection.
77.
Put keyway (31) on armature shaft.
78.
Place pulley (30) on an induction heater. Heat part to 212°F (100°C).
79.
Remove pulley (30) from heater and install on armature shaft. Hold firmly until cooled.
80.
Install lockwasher (29) and nut (28).
81.
Install brushes. Refer to TM 55-2210-223-12 for brush adjustment data.
3-150
