TM 55-2210-224-34
3-35. SPEED-SENSING ALTERNATOR (cont)
DISASSEMBLY
6. Remove seven capscrews (15), lockwashers (16),
flat washers (17), cover (18), and gasket (19).
7. Tag and disconnect wires from coil of stator (27).
8. Remove locking screw (20) and flat washer (21).
Use a puller and pull rotor (22) from shaft and
bearing assembly (33).
9. Remove four screws (23), lockwashers (24), flat
washers (25), and spring clips (26) and remove
stator (27).
10. Drive out two roll pins (28) and remove spade (29)
and flexible coupling (30).
11. Remove four screws (31) and retaining ring (32)
from inside housing (35).
12. Remove shaft and bearing assembly (33) and oil
seal (34) from housing (35). Remove pin (36) from
shaft and bearing assembly.
3-141
