Sec. 3--Fig. 11
RIPPERS, ROOTERS AND SCARIFIERS, LENGTHWISE-FLAT CARS
Item
No. of Pcs.
Description
A
Brake wheel clearance. See Fig. 2.
B
2
Blocks, pattern 6. Locate one against each side of tongue, as shown. Nail each to floor with two
60-D, three 40-D and one 20-D nail in heel and one 40-D nail in each side of block.
0
8
Blocks, pattern 1. Locate two, side by side, in front and back of each wheel. Nail each to floor
with two 60-D, three 40-D and one 20-D nail in heel and one 40-D nail in each sidefo block.
D
4
2 in. x 4 in. x 24 in. Locate two, lengthwise of car, against outside of each wheel. Nail lower
pieces to floor with five 40-D nails in each and top pieces to the ones below with five 40-D
nails in each.
E
2
2 in. x 6 in. x 44 in. Locate one under each outside Ripper tooth and nail to floor with six 40-D
nails.
F
4
Blocks, pattern 8. Locate one under each outside Ripper tooth on top of Item "E" and one
against each corner of tongue as shown. Nail each to Item "E" or floor with two 60-D, three 40-
D and one 20-D nail in heel and one 40-D nail in each side of book.
G
8
2 in. x 4 in. x 14 in. Locate one on top of each Item "E" and on floor behind each Item "F" and
one on top of each Item "E" in front of each outside Ripper tooth. Nail each with four 40-D
nails.
H
2
Each to consist of two blocks. 2 in. x 4 in. x 14 in. Locate lower pieces on floor against the
outside of Items "E". Nail lower piece to floor with four 40-D nails and top piece to the one
below with four 40-D nails.
See General Rules 4, 5, 7, 9, 14 and Fig. 1-B for further details.
F-12
