TM 55-2210-223-34
TO 45A2-2-14-22
3-28. MAGNETIC REVERSER SWITCH (cont)
ASSEMBLY
21.
Assemble bottom terminal and limit switch assembly (29) by the following:
a.
Install resistor (65) and resistor guard (64) on bottom terminal (66). Coat two screws (62) with sealant and install
screws and lockwashers (63).
b.
Install limit switch (60) on switch bracket (61). Secure with two lockwashers (59) and screws (58).
c.
Install limit switch assembly (57) on bottom terminal (66). Coat two screws (56) with sealant and install.
d.
Install wiring harness (55) on bottom terminal (66). Install capacitor (54) on back of limit switch assembly (57)
and connect wires.
e.
Install two screws (53), flat washers (52), lockwashers (51), and nuts (50).
f.
Install rectifier assembly (49), sleeve (48), clamp (47), flat washer (46), and screw (45).
23.
Assemble magnet assembly (22) by the following:
a.
Install spring washer (43) and magnet coil (42).
b.
Install pole plate (41) and secure with lockwasher (40) and screw (39).
24.
Assemble top terminal assembly (18) by the following:
a.
Install eight wipe springs (37), pivot springs (36), and caps (35) on top terminal (38).
b.
Install eight stationary contacts (33), four spacers (34), and four contact assemblies (32) on top terminal (38).
Secure with eight lockwashers (31) and allen-head screws (30).
25.
Install armature and operator assembly (28) over movable contact assembly on limit switch assembly (29).
26.
Install insulator (27) and interlock assembly (26) on limit switch assembly (29), with armature and operator
assembly (28) in slot of interlock assembly.
27.
Install flat washer (25), lockwasher (24), and allen-head screw (23).
28.
Install magnet assembly (22) on limit switch assembly (29). Secure with two flat washers (21), lockwashers (20),
and allen-head screws (19).
29.
Connect wires and remove tags.
3-100
