TM 55-2210-223-34
TO 45A2-2-14-22
3-31. BATTERY CHARGING RESISTOR (cont)
REMOVAL (cont)
TEST
4.
Use a multimeter and perform a resistance test on the battery charging resistor. The resistor value should be
0.05 ohms. If this reading is not obtained, replace defective resistor.
INSTALLATION
5.
Install resistor assembly (10) and secure with four capscrews (9), flat washers (8), star washers (7), and nuts (6).
6.
Connect wiring to resistor assembly (10) and secure with two bolts (5), lockwashers (4), and nuts (3).
7.
Install resistor cage (2) and secure with six screws (1).
3-108
