TM 55-2210-223-24
TO 45A2-2-14-22
3-35. EXCITER-AUXILIARY GENERATOR ASSEMBLY
This task covers:
a.
Removal
c.
Cleaning
e.
Repair g.
Assembly
b.
Disassembly
d.
Inspection
f.
Test
h.
Installation
INITIAL SETUP:
Tools
Material/Parts
Tool kit SC 4940-97-CL-E12
Drycleaning solvent (Item 30, Appendix B)
Dial indicator 5210-00-640-0953
Grease BB (Item 12, Appendix B)
Portable propane torch 3439-00-542-0531
Clear acrylic lacquer (Item 17,
Induction heater 2815-00-366-1432
Appendix B)
Red insulating varnish (Item 33,
Appendix B)
Gray gloss enamel (Item 9, Appendix B)
Electrical tape (Item 32, Appendix B)
Wiping rags (Item 28, Appendix B)
Test Equipment
Multimeter 6625-01-139-2512
Megohmmeter 6625-00-456-7442
REMOVAL
WARNING
Remove rings, bracelets, wristwatches, and neck chains before working around the locomotive.
Jewelry can catch on equipment and cause injury, or may short across an electrical circuit and cause
severe burns or electrical shock.
High voltage is used in the operation of equipment. Do not be misled by the term LOW VOLTAGE.
Potentials as low as 50 volts may cause death.
1.
Set battery switch to OPEN position. Tag and disconnect wiring (1) from terminals.
2.
Loosen four bolts (2).
3.
Refer to TM 55-2210-223-12 and remove drive belts.
4.
Remove four bolts (2) and flat washers (3) and (4).
5.
Turn adjusting nut (5) and free adjusting screw (6) from mounting bracket (7).
3-117
