TM 55-2210-224-34
4-8.
AIR COMPRESSOR ASSEMBLY (cont)
ASSEMBLY (cont)
80.
Assemble high-pressure discharge valve (46) by the following:
a.
Assemble valve seat (53), valve disc (52), three valve springs (51), and valve bumper (50).
b.
Secure with screw (49) and nut (48).
81.
Use a small amount of grease to hold in place and install ring gasket (47) on high-pressure discharge valve (46).
Slowly lower discharge valve into high-pressure cylinder head (103). After valve is in place, rotate to be sure it
is-seated and free.
82.
Position valve clamp (45), seat gasket (44), and valve cover (43) and install three capscrews (42). Install
setscrew (41), gasket (40), and acorn nut (39).
83.
Position gasket (38) and flange (37) on housing (171) and install two capscrews (36).
84.
Position gasket (35) and flange (34) on high-pressure cylinder head (103) and install four screws (33). Install
nipple (32) in flange and install elbow (31) and flex pipe (30).
85.
Install felt gasket (29) and clamp (27) on breather (28). Position breather on breather tube assembly (25) and
tighten clamp. Position gasket (26) and breather tube assembly on housing (171) and install two capscrews (24).
86.
Position gasket (23) and suction manifold (22) on low-pressure cylinder head (97) and install two capscrews (21),
nipple (20) and elbow (19).
87.
Position gaskets (113) and (110) and inspection plates (112) and (109) on housing (171) and install eight
capscrews (111) and (108). Install oil level gage (114) in inspection plate (112).
88.
Assemble air filter assembly (12) by the following: a. Install air filter element (17) in body (18). b. Position cover
(16), cork gasket (15), and flat washer (14) on body (18) and install wing nut (13). c. Install air filter assembly
(12) on elbow (19).
89.
Position two gaskets (8) and intercooler (7) on high-pressure cylinder head (103) and low-pressure cylinder head
(97) and install four capscrews (6). Install two pet cocks (11), elbow (10), and safety valve (9) on intercooler.
4-29
