TM 55-2210-223-34
TO 45A2-2-14-22
3-35. EXCITER-AUXILIARY GENERATOR ASSEMBLY (cont)
ASSEMBLY (cont)
CAUTION
Procedures specify the heating of parts to aid in disasembly and assembly. Heated parts may cause injury
to personnel if hand protection is not worn when handling. Wear protective gloves for maximum
protection.
35.
Heat inner race (45) on an induction heater to 230°F (110°C) and install on shaft.
36.
Install bearing assembly (44).
37.
Fill inner bearing housing (34) and bearing assembly (30) with grease.
38.
Install inner bearing housing (34), gasket (33), bearing spacer (32), inner race (31), and bearing assembly (30) on
shaft.
39.
Install brushes and brush holders. Refer to TM 55-2210-223-12 for brushes and brush holder installation.
40.
Install locknut (43) and secure with two setscrews (42).
41.
Install auxilliary end housing (41), eight lockwashers (40), and bolts (39).
42.
Install gasket (38) and auxiliary end cap (37). Secure with six lockwashers (36) and bolts (35).
43.
Install oil slinger (29).
44.
Install exciter end housing (28) and secure with eight lockwashers (27) and bolts (26).
45.
Install gasket (25) outer bearing housing (24), and secure with six lockwashers (23) and bolts (22).
46.
Install key (21) and inner pulley (20) on shaft and secure with three bolts (19).
47.
Install pulley (18) and secure with three lockwashers (17) and bolts (16).
48.
Install screen (15) and secure with three flat washers (14), lockwashers (13), and bolts (12).
49.
Adjust brush holders and brushes. Refer to TM 55-2210-223-12 and adjust brushes.
50.
Install two covers (11) and secure with six flat washers (10), lockwashers (9) and bolts (8).
3-131
