TM 55-2210-223-34
TO 45A2-2-14-22
3-18. BATTERY CHARGING RECEPTACLE (cont)
CLEANING, INSPECTION, AND REPAIR
WARNING
Dry-cleaning solvent P-D-680 is toxic and flammable. Wear protective
goggles and gloves and use only in a well-ventilated area. Avoid contact
with skin, eyes, and clothes and don't breathe vapors. Do not use near
open flame or excessive heat. The flash point is 100-138°F (38-59°C). If
you become dizzy, get fresh air and get medical aid, immediately. If
contact with eyes is made, wash your eyes and get medical aid
immediately.
Compressed air used for cleaning purposes will not exceed 30 psi (207
kPa). Do not direct compressed air against skin. Use goggles or full face
shield.
12.
Use a cloth dampened with solvent and clean parts. Dry with compressed air.
13.
Inspect contacts for pitted or burned areas. Replace damaged contacts.
14.
Inspect housing for bends or dents. Replace damaged housing.
15.
Inspect for broken or frayed wiring. Replace damaged wires.
TEST
16.
Use a multimeter and perform a continuity test on the battery charging receptacle. Replace defective parts.
17.
Use a megohmmeter and perform a resistance test on the battery charging receptacle. Replace defective parts.
ASSEMBLY
18.
Install wire through receptacle housing (9).
19.
Connect wires to two terminal lugs (11). Remove tags.
20.
Install two terminal lugs (11) on receptacle (8) and secure with two screws (10).
21.
Install receptacle (8) into receptacle housing (9).
22.
Install gasket (6), insulation sleeve (7), and receptacle cap (5) on receptacle housing (9) and secure with four
lockwashers (4) and screws (3).
INSTALLATION
23.
Install receptacle assembly (2) and secure with four bolts (1).
24.
Connect positive lead to batteries.
3-59
