TM 55-2210-224-34
3-28. REVERSER (Cont)
ASSEMBLY
34.
Assemble magnet valve assemblies (19) and (23) by the following:
NOTE
Magnetic valve assemblies are identical and are assembled in the same manner.
a. Install valve stem (138) in valve body (139). Position magnet frame (137), on valve body and install two
screws (136).
b. Position rubber washer (135) and coil (134) on valve stem (138) install retaining ring (133).
c. Position armature (132) and armature guide (131) on valve stem (138) and install two lockwashers (130)
and screws (129).
d. Install inlet valve (128), spring (127), gasket (126), and cap plug (125).
35. Position packings (123) and followers (122) in piston (124) and install two self-locking nuts (121).
36. Install piston assembly (120) in top end frame (106) and install gasket (119), cylinder head (118), eight
lockwashers (117), and bolts (116). Install guide block (115) and rotate 90 degrees.
37. Position shaft (114) and install sleeve (113), spacer (112), three insulators (111), four support barriers (110),
sleeve (109), and thrust bearing (108).
38. Install bottom end frame (107) and top end frame (106) on shaft (114).
39. Position 8 fingers (105), seats (104), springs (103), and supports (102) on support barrier (109) and install 16
lockwashers (101) and screws (100).
40. Position four supports (99), five sleeves (98), and rod (97), and install two lockwashers (96) and bolts (95).
41. Install four spacers (94), bolts (93), flat washers (92), flat washers (91), lockwashers (90), and nuts (89).
42. Position four supports (88) and five sleeves (87). Install rod (86), two lockwashers (85), and bolts (86).
43. Position four spacers (83) and bus bar (82) and install four flat washers (81) and carriage bolts (80), flat washers
(79), lockwashers (78), and nuts (77).
44. Position four supports (76) and five sleeves (75). Install rod (74), two lockwashers (73), and bolts (72).
3-123
