TM 55-2210-224-34
3-63. TRUCK ASSEMBLY (cont)
ASSEMBLY
39.
Assemble traction motor-gear-unit to wheel-axle-assembly (62) by the following:
WARNING
Components of the main generator are heavy and may be awkward to handle. Use correct lifting
procedures, indicated lifting devices, and/or assistance from other personnel to avoid injury.
a.
Use a suitable lifting device and place traction motor-gear-unit assembly (125) upside down on the floor.
b.
Use a suitable lifting device and raise wheel-axle assembly (124) and position over traction motor-gear-unit
assembly (125). Lower wheel-axle assembly into gear unit.
c.
Install two axle linings (123) and axle caps (122). Install four lockwashers (121) and capscrews (120).
d.
Install gasket (119) and gear unit cover (118). Install 17 lockwashers (117) and capscrews (116).
e.
Position gasket (115) and 2 seal rings (114), and install 10 lockwashers (11
3) and capscrews (112).
40.
Use a suitable lifting device and turn traction motor-gear-unit wheel-axle-assembly (62) over onto the wheels.
41.
Assemble frame assembly (61) by the following:
a.
Install spacer (110) and lever (109) on frame (111) and install spring (108) and nut (107).
b.
Install spring (108), spring seat (105), cotter pin (104), spacer (103), brakehead (102), spacer (101), pin (100),
and cotter pin (97).
c.
Position lever (98) and install pin (97), cotter pin (96), brakehead (95), two l
evers (94), pin (93), and cotter pin
(92).
d.
Install spring (91), bracket (90), cotter pin (89), and two nuts (88).
e.
Install center plate (87), center plate wear ring (86), and center plate dust guard (85) on frame (111) and install
eight lockwashers (84) and capscrews (83).
f.
Use a suitable lifting device and position inner equalizer (82) inside frame assembly (61). Position outer
equalizer (81) on outside of frame and chain inner and outer equalizers to frame.
3-230